|
|
| 1 | Spray a large baking tray with cooking oil spray or line with ovenproof parchment paper and set aside. |
|
| 2 | Place the dry yeast in a small bowl and pour the 1/3 cup of warm water slowly over it. Mix gently with a fork and set aside for 5 minutes. |
|
| 3 | Place the sugar, salt, and butter into a large mixing bowl. Pour over the boiling water and stir until the butter has melted. |
|
| 4 | Add the cold water and stir. Add the yeast mixture and stir again to blend. |
|
| 5 | Add half the flour to the bowl and stir, using a wooden spoon, until the dry is incorporated into the wet. Add enough of the remaining flour until a soft dough forms, about 2 cups. Turn out onto floured work surface and knead, adding another 1/2 to 1 cup flour as you knead. Continue kneading until the dough is soft, supple, elastic and no longer sticks to the work surface, about 6 minutes. Leave the dough to rest for 5 minutes. |
|
| 6 | Preheat the oven to 175°F (80°C). (The low starting temperature gives the bread a little rising before you hit it with the heat). Divide the dough into three equal portions and let it rest for another 5 minutes. |
|
| 7 | Using your fingertips, spread each portion of dough out into a rectangle. Roll each rectangle up like a Swiss roll lengthways and then tuck the two ends underneath. Place each rolled loaf on the baking sheet seam side down and gently even out the "log" or loaf. |
|
| 8 | Spray a sharp knife with cooking oil spray (or rub with vegetable or olive oil) and make three deepish, diagonal slashes into the tops of each loaf. |
|
| 9 | Brush with the beaten egg and bake at 175°F (80°C) for 15 minutes. |
|
| 10 | After 15 minutes, increase the oven temperature to 400°F (200°C) and bake for a further 15 - 20 minutes. |
|
| 11 | Turn the oven temperature down to 350°F (180°C) and bake for a further 10 - 15 minutes or until the tops are golden, the bottom of the loaves are colored, and the bread sounds hollow when knocked. |
|
| 12 | Transfer the loaves to a wire rack to cool (a little) before slicing. |
|
| | |
|
